Telex BP-1000 Single-Channel Beltpack- USED

$100.00

QTY 4 available

Description

The Audiocom® BP-1000 is microprocessor controlled one-channel intercom belt pack. An internal switch and jumper setting allows the units to be used with Clear-Com® components, if desired. Other internal switch and jumper settings allow the unit to be uniquely configured to the operator’s requirements.

The BP-1000 belt pack receives power externally, via the intercom channel.

The BP-1000 will pass system power through to subsequent belt packs that are “daisy chained” together.

BP-1000 SETUP

The channel termination is initially set for balanced operation, which is compatible with other Audiocom® equipment. If the unit is going to be connected to Clear-Com equipment, one switch and several jumpers must be changed as described in the section on Clear-Com Setup in the manual.

The headset microphone type is initially set for single-ended dynamic operation. To change the microphone type to balanced dynamic, refer to Table 2 for the position of J15.

To change the headset microphone to an electret type, refer to Table 2 in this manual for the position of switch SW1. If the type requirement of a headset microphone is unknown, the recommended setting is single-ended dynamic.